Exceptional corrosion protection in salt and fresh water immersion and corrosive chemical environments
Surface tolerant, lowers the cost of surface preparation
Excellent adhesion to tight rust
Good adhesion to damp surfaces
Low temperature cure, cures down to 0°F (-18°C)
Fast dry-to-recoat
Self-priming
Low solvent content meets VOC requirements, reduces the chances for film pinholing and solvent entrapment at the substrate-coating interface, often a major cause of coating failure with conventional epoxies and lower solids systems.
Typical Uses
Tank Linings and Pipe Coatings
Ballast tanks
Bilges, wet voids and drainage pipes
Ships, Offshore and Marine Structures
Above and below-water hull areas
Decks and superstructures
Multi-purpose repair coating
Fabrication and New Construction
Speeds up production, even at low temperatures
A single multi-purpose, surface-tolerant coating
Please note colors on your computer screen may vary from the actual manufacturer's color. To view the most accurate swatch color please contact the manufacturer's website.
Provides a permanent, protective satin coating that will not yellow with age. Moisture-resistant and smudge-proof. Improves artwork and photo contrast.
Can be topcoated as soon as Dimetcote 302 is solvent free
Outstanding resistance to water, weather and abrasion
Superior performance on marine hulls, decks and superstructures
Resistant to dry spray, mudcracking and topcoat bubbling
Easily applied by airless or conventional spray and brush
Typical Uses (with suitable topcoats)
INDUSTRIAL - Structural steel, machinery pipes, and tank
exteriors in paper mills, oil refineries, power plants,
chemical process and waste treatment plants.
MARINE - Decks, hulls and superstructures of ships,
barges and workboats. Piers, offshore platforms and related
structures.
A high performance, low VOC, two-component chemically-cured aliphatic urethane gloss finish. NORTH AMERICA ONLY
For use on properly prepared steel, galvanized, aluminium and properly prepared concrete floors.
Ideal for use on exterior or interior structural steel, piping, metal buildings, conveyors, pumps,
storage tank exteriors, wind turbine towers, motors, machinery, and transportation vehicles.
Can also be used in the hard service areas of food processing plants, dairies, schools, restaurants,
hospitals, correctional facilities, factories, stadiums, arenas, and amusement parks.
Please note colors on your computer screen may vary from the actual manufacturer's color. To view the most accurate swatch color please contact the manufacturer's website.
Walnut Shell Grit is easily added to paint, mixed-in and applied to surfaces to create a non-skid / anti-slip coating. Walnut Shell abrasives stay in suspension in most paints, for easy mix-in applications.
